Fitting Stems and Crowns to Watches

Things to consider when selecting proper crown: (1) color, (2) tap, (3) outside diameter, (4) inside diameter, (5) post length, (6) overall thickness, (7) design of watchcase. The most common problem you will have when fitting stems is that the stem will be cut too short and rendered useless. One good way to fit stems with a minimum of difficulty is to do the following:

  1. Remove old stem.
  2. With movement in case, insert new stem.
  3. If case is waterproof cut stem 1.5 mm from end of case tube; for dustproof cases, cut stem 1.5 mm from edge of case; for watches that use crowns with long posts, cut stem flush with case or tube (see image below).
  4. Remove stem from watch.
  5. Grip stem in notch with end-cutting pliers and screw crown onto stem tightly (see image below).
  6. Replace stem into watch.
  7. Measure the distance from the edge of the tube or case to the inside edge of the crown.
  8. Remove the crown and cut the measured amount off from the stem minus about 0.25 mm to allow for stoning (see image below).
  9. Stone down the end of the stem to make it flat and round over edges (see image below).
  10. Place a very small amount of LOC-TITE or Superglue on the end of the stem.
  11. If waterproof, place a small amount of silicone on case tube, then repeat steps 5 & 6 and you’re done.

Fitting stems will take practice, but if you use this method you will have less problems.

There are some other things to consider when fitting new stems. Check the pilot hole and other bearing surfaces for excessive wear. If worn excessively you will need to purchase or make a new oversized stem to correct the problem.

Quartz watches generally use smaller crowns than mechanical watches.

Cut stem 1 mm from edge of case or tube

Cut stem 1 mm from edge of case or tube

Use end cutting pliers to hold and cut stems

Use end cutting pliers to hold and cut stems

Fresh cut stem on left, stem with end finished on right

Fresh cut stem on left, stem with end finished on right

Finishing stem end using lathe and stone

Finishing stem end using lathe and stone

Fitting Stems and Crowns to Watches2019-09-14T12:42:13-04:00